News and Events
Teledyne Proudly Powers NASA's
Teledyne Acquires PDM Neptec
Rubber Molded/Glass Reinforced Epoxy
Inverted Rubber Molded/Glass Reinforced Epoxy
Glass Reinforced Epoxy
Metal Shell PBOF
Micro Wet Pluggable
IE55 Rubber Molded/Metal Shell
IE55V Inverted Rubber Molded/Metal Shell
IE Underwater Pluggable
Magnetically Operated Proximity Switches
Miniature High Density
Miniature High Density - Oil Filled
Metal Key Titan®
Terms and Conditions
Pressure balanced design allows underwater mating and unmating of cable assemblies (power off).
Molded neoprene inline connectors supplied on 24" of #18 AWG SO cable (2 contact on SJO). Series 3 connectors supplied on 24" length of #16 AWG SO cable unless otherwise specified.
Bulkhead connectors have brass or stainless steel threaded body depending on connector type. They are supplied with 12" of #18 AWG type E Teflon or Belden 34918 neoprene inboard leads. Series 3 connectors supplied with #16 AWG inboard leads.
Up to 10,000 PSI pressure rating in mated condition (see
Bulkhead connectors open face pressure rated to 5000 PSI.
All mounting surfaces require a 32 finish.
Lubricate male pins liberally with Dow Corning #111 Valve Lubricant or equivalent and apply a small amount in each female socket. Connectors must be lubricated on a regular basis.
Lubricate O-rings with Dow Corning #111 Valve Lubricant or equivalent.
Keep O-ring grooves clean and avoid cuts and nicks in the O-ring. Replace O-rings when re-mounting connectors.
Avoid contact with solvents.
Elastomers can be seriously degraded if exposed to direct sunlight or high ozone levels for extended periods of time.
Grip main body of connector during mating or unmating. Do not pull on the cable to disconnect.
Avoid sharp bends at cable entry to connector.
# of Contacts
Mated Pressure Rating(PSI)
Teledyne Impulse • 9855 Carroll Canyon Road • San Diego, CA 92131
858.842.3100 • 800.327.0971
Copyright © 2012
Teledyne Technologies Incorporated
. All rights reserved.